Class 1 : Speed – Power – Frequency
On session number one we're just going to talk about that general overview. Again we're going to do a deep dive on speed power and frequency.
0/8
Class 2 : Adobe Illustrator
We're going to be migrating over to Adobe Illustrator. Now this is where 90% of everyone struggles. You can't do anything really on a laser until you get a template. So we're going to do a deep dive into that.
0/7
Class 3 : 2.5d Engraving
0/4
Class 4: Test Generator and Non-Metals
On today's lesson, we're going to take a little bit of a deeper dive inside of Light Burns test generator. Now we're going to be working with nonmetals. A lot of metals are very similar, but you'll see when you get outside of that you'll be having to use this tool a whole lot. So hopefully it comes in handy. I'll see you guys there.
0/5
Class 5: Jewelry / Cutting
I'm pretty excited about today's class. Today we're making jewelry. Now this just goes hand in hand with just cutting in general. Now we are going to be using a method called offset. I'm not the biggest fan of wobble because I feel like it's not as accurate as this method. Our method will be a little bit slower, but it's very important to have the best quality.
0/7
Class 6: Firearms Deep Engraving
Now, today might be the moment so many of you may have been waiting for it. We're going to do our first firearm. It is going to be a test. Blaine provided by somebody in the laser groups. We'll supply his name below. Now, not only will we be doing a deep engraving on this, but you get to watch me go through Adobe and stack through this artwork. Don't get intimidated. Remember to take it slow and always just take notes. See you guys there.
0/6
Class 7: Multi Color Engraving
On today's class, we're going to do multiple color engraving on a P-Mag. Now this same technique can be applied to stainless steel or anything else. We'll provide a couple of test charts to go along with this video. It's going to be a fun one. See you there.
0/4